Drying box series products, volume of 30, 50, 70, 140, 240 liters of five specifications. The outer shell of the drying oven adopts high quality steel plate surface baking paint, the studio adopts general galvanized steel plate or mirror stainless steel plate, the working room is equipped with two layers of stainless steel wire shelf, the middle layer is filled with ultra-fine glass wool insulation. Double-layer toughened glass is used on the door as the observation window, which can clearly observe the items in the box. A heat-resistant silicone rubber sealing ring is installed at the connection between the workshop and the door to ensure the sealing between the workshop and the door. The drying box power switch, power indicator light, throttle adjusting knob, temperature controller and other operating parts are concentrated in the control panel in front of the box, located in the left front side of the box. The heating and constant temperature system in the box is mainly composed of a motor equipped with centrifugal impeller, an electric heater, a reasonable air duct structure and a temperature controller. When the power supply of the drying box is connected and the fan switch is turned on, the motor will run, and the heat generated by the electric heater at the back of the box will be directly discharged upward through the air duct, and the dry items in the working room will be sucked into the fan, so as to keep circulating, so that the temperature in the working room can reach uniform. Intelligent temperature controller, with automatic wind speed regulation function, in the process of heating up, the motor runs at high speed, when the temperature is close to constant, automatic adjustment to low speed operation, so as to reduce the use of problems caused by too fast wind speed. Users can also disable this function by performing simple operations. The air valve regulator can adjust the amount of air in and out of the box by opening the air valve adjustment knob.
Characteristics of drying oven series:
1. Cuboid studio, maximizing the use volume.
2, special equipment strengthening device, with the use of thickened stainless steel liner, to ensure the long-term use of equipment liner deformation.
3, toughened glass door, good sealing, observe the objects in the working room, at a glance.
4, the whole silicone rubber door seal ring, to ensure excellent sealing performance of the equipment.
5, temperature control using digital display touch buttons, touch setting, digital and direct display, temperature control heating, cooling, system completely independent can improve efficiency, reduce testing costs, increase life, reduce failure rate.
6, the overall equipment overtemperature; Overall equipment underphase/inverse phase; Overall equipment overload; Overall equipment timing;
7, other leakage, operation instructions, automatic shutdown after failure alarm protection.
Post time: Feb-05-2022
