GM-1 Roller Type Abrasion Testing Machine

The roller type abrasion tester is mainly composed of a power system, a rotating roller, a sample holder, an automatic shutdown system and a rack and pinion gear device for sample rotation, a base and a dust collector, etc.

Product Description:
The roller type abrasion tester is mainly composed of a power system, a rotating roller, a sample holder, an automatic shutdown system and a rack and pinion gear for sample rotation, a base and a dust collector. The main principle of the roller abrasion tester is: under a certain load, on a de facto grade emery cloth, the cylindrical sample is cross-cut and ground on the surface of the emery cloth for a certain stroke, by measuring the mass abrasion of the sample, and then The volume wear was calculated from the density of the sample. In order to make the test comparable, a standard rubber must be used at the end, and the test result is expressed as the relative volumetric wear based on the calibrated grinding wheel or as the wear-resistant base number relative to the wear of a certain standard rubber.

Technical Parameter:
1. Roller diameter: 150±0.2mm
2. Roller length: 460mm
3. Roller speed: 40±1r/min
4. Samples used: diameter: 16±0.2mm, thickness not less than 6mm
5. Transverse speed of sample holder: 4.2±0.06mm/r
6. Grinding stroke length: 20m or 40m
7. Sample rotation speed: 0.9r/min or no rotation
8. Self-load: 2.5N (generated by sample holder and cantilever)
9. The sample load can be adjusted to weight: 5N, 7.5N, 10N, 12.5N, 15N, 17.5N, 20N (with three attached weights)
10. Output power: AC220V 50Hz
11. Motor speed: 3000r/min